DDT Handguns

"Invigorator"

The Invigorator is a limited edition based on the DDT "Death's Head" longslide automatic. Chambered for the .50AE round rather than the standard .44 Magnum the Invigorator comes with fully personalised grips and match precision sights. Due to the weight of the gun (especially the slide) the recoil is considerably lower than would normally be expected from such a potent round. With it's long barrel the Invigorator is also a remarkably accurate weapon.

A heavy, longslide semi-automatic with a front end barrel weight which has a removable plug ready to accept a laser painter, the Invigorator is a little over 30cm long from hammer to muzzle wit a barrel length of 19.4cm!

The Invigorator cannot be fitted with a silencer due to the weight of the slide. The gas bleed technique used to slow the bullet to sub-sonic speeds would result in the gun not having enough blow-back to cycle properly, thus causing the gun to jam. The same problem also prevents recoil compensation being fitted.

Available in Basic Black, Hi-Crome, Steel, Brushed Steel or Nickel Plate

 

CLIP

CAL

ROF

RCL

RNG

Weight

Cost

Invigorator / Invigorator K

8+1

.50AE

1

6

22m

2.4kg

810c

The Invigorator K is a heavier (2.2kg); more robust version of the Invigorator built with the delivering of a pistol whipping in mind (Use the 1H-Club skill). The Invigorator K costs 835c

Invigorator K close combat stats:

PEN

DAM

AD

 

0

2

1

.50 calibre is the same as 12.7mm. The Invigorator can fire any 12.7mm round from the MRB / Karma however .50AE rounds have slightly different stats to the standard 12.7mm. Note that it is not recommended to fire AE rounds from a weapon not designed for their use.

"Death's Head"

DDT's original entry into the firearms market was this excellent longslide semi-automatic, designed for people who wanted a little more punch than you get from a standard 10mm round but without the excessive recoil that comes with 12.7mm rounds. At 26.9cm in length with a 15.2cm barrel and the now distinctive front weight for recoil reduction the Death's Head has been easily successful enough to fund the development of the Invigorator and with the release of the larger gun this weapon has received increased public interest. Following the strategic alliance between DDT and GA the Death's Head is being diliberatly positioned as a high quality alternetive to the FEN 603

The Death's Head comes with match precession sites and high comfort grips and is available in Basic Black, Brushed Steel or Nickel Plate.

 

CLIP

CAL

ROF

RCL

RNG

Weight

Cost

Death's Head

13+1

.44 Magnum

1

2

15m

1.8kg

190c

.44 Magnum Rounds are not equivalent to any standard ammo type used by SLA Industries. Ammunition for the Death's Head is available only through GA approved suppliers.